Common problems and solutions of laser cutting robot:
Cutting machining holes (small diameter and thickness) on the basis of analysis on deformation: this kind of situation mainly because of machine tool in processing is not with the method of blasting hole, but with the pulse perforation (soft puncture), which makes the laser energy is too concentrated in a small area, will not processing areas also burned, cause hole deformation, affect the processing quality.At this time, we should change the pulse piercing (soft puncture) mode into blasting piercing (ordinary puncture) mode in the processing program to solve the problem.However, for the laser cutting machine with low power, it is exactly the opposite.
Laser cutting low carbon steel, the workpiece burr solution: laser focus on the upper and lower position is not correct, need to do the focus position test, according to the focus of the offset adjustment;The output power of the laser is not enough. It is necessary to check whether the laser generator works normally. If it works normally, observe whether the output value of the laser control button is correct and adjust it.Cutting line speed is too slow, need to increase the line speed when the operation control;The purity of cutting gas is not enough, high quality cutting gas is needed;Laser focus offset, focus position test needs to be done, according to the focus offset adjustment;Machine running time too long instability, the need to restart the shutdown.
Laser cutting processing of stainless steel and coated aluminium zinc plate, artifacts have burrs generated by analysis: the emergence of this situation, first of all to consider the factors when cutting mild steel burr, but not simply speeds up the cutting speed, because of the increased speed sometimes plate cutting wear, the situation especially when processing coated aluminium zinc plate.At this time should be comprehensive consideration of other factors to solve the machine, such as whether to replace the nozzle, guide rail motion instability.
About laser cutting robot common problems and solutions, for you so much, also pay special attention to in the process of robot in the operation of the above problem, a method for the solution of these problems by heart, if you have what not understand place of above content, can leave a message in this web site, small make up will reply in time.
公众号
小程序
广东运特股权投资有限公司
GuangDong Wintech Equity Investment Co. Ltd运特贸易(东莞)有限公司
Win-Tech Trading (DongGuan) Co,Ltd运誉智能科技(上海)有限公司
Win-Honor Intelligrent Technology(ShangHai)Co,Ltd